Enigma Semi-Full PRO mode This application is dedicated to operation.
This application is for Enigma Semi-Full only. It can not be used for the conventional ENIGMA and FirePlus series.
This application is only for PRO mode which can set the ignition time. Professional knowledge is required to set the ignition timing. EASY mode has special application which can make adjustment from ignition timing of normal ECU without advanced expert knowledge.
This application can be downloaded for free. When it is free, you can connect with all Enigma Semi-Full, but only the tachometer screen is displayed. (Only tachometer and TPS are displayed).
In order to set various functions of Enigma Semi-Full, you need to purchase the model data corresponding to Enigma Semi-Full you have from the model selection screen.
When purchasing and selecting model data, the following functions can be used.
· Preset data combined are prepared. Preset data can be easily written to Enigma Semi-Full.
· The ignition timing of 0 - 60 degrees can be adjusted for each engine rotation / throttle position. It is also possible to set the dwell time.
- The fuel injection amount can be set for each engine rotation / throttle position.
- Fuel correction at idling can be performed.
- Adjustment of fuel injection time by engine temperature and intake air temperature is possible.
- It is possible to set injection timing at each rotation speed.
- Various maps can be displayed in 3D graph.
- Two maps can be put inside Enigma Semi-Full, and it can be switched with an external switch.
- In real time, you can display tachometer, throttle opening monitor, injector opening / closing rate, oil / water · engine temperature (depending on model).
- Display the current engine speed and throttle position in real time in the fuel map.
- Revolution Limit can be set .
- Pit-in limit can be set (Applicable model only)
- Digital acceleration pump can be set.
- It is possible to correct the TPS sensor according to the actual machine.
- You can make several fuel data and save it, you can change it immediately when you need it.
- It corresponds to Japanese and English.
Note You can not connect to some terminals manufactured by Fujitsu or not made in Japan's due to problems on the terminal side. Please note that you purchase. (You can check whether you can connect with your Android terminal before purchasing model data.)
Pairing setup is required before connecting. When pairing and when connecting for the first time after pairing, keep the distance to Enigma Semi-Full as close as possible to within 30 cm.
There is no direct linkage function of data with other Androrid terminal, PC version or iOS version. Migrate the data via Enigma Semi-Full.
Refunds on model add-ins purchased in in-app billing are not accepted basically.
Please be careful that there are no mistakes in model.
This application contains deliverables distributed under license of Apache License, Version 2.0.
-Add model GROM JC61
-Add model GROM JC75
-Add model MONKEY125 JB02
-Add model Z125 Pro
-bug fix data read error on preset write page
-Add model CYGNUS-X SE44J
-Correct MAP TYPE of IDLE AREA
-Fixed problem can select MAP2 at preset map write.
© 2019 Juara Game. All Rights Reserved.